Execute an inspection instruction on samples

After a new inspection instruction (check, input or measurement type) is added, you can set whether it must be executed on samples.

  1. Choose Inspection Management > Inspection Instructions in the Navigation Pane.
  2. Select the inspection instruction (type check, input or measurement).
  3. Choose the sub tab Samples.
  4. Check the fields below in the option group Settings if necessary:
    FieldExplanation
    Samples required for inspection The inspection is executed on samples.
    Inspection is destructive After the inspection, the sample is unusable.
  5. In the option group Samples, complete the fields below:
    FieldExplanation
    # Samples Enter how many samples must be inspected.
    Sample Type Enter the sample type or click Sample Type Selection and select the sample type. (not mandatory).